Asked by: Desamparats Potau
asked in category: General Last Updated: 9th February, 2020

What should map sensor read with engine off?

When the engine is off, the absolute pressure inside the intake equals atmospheric pressure, so the MAP will indicate about 14.7 psi. At a perfect vacuum, the MAP sensor will read 0 psi. With a running engine, intake manifold vacuum usually runs around 18 - 20 “Hg (inches of mercury).

Click to see full answer.


In this way, what should map sensor read at idle?

A MAP sensor that reads 1 or 2 volts at idle may read 4.5 volts to 5 volts at wide open throttle. Output generally changes about 0.7 to 1.0 volts for every 5 inches Hg of change in vacuum.

One may also ask, how do I know if my map sensor is bad? To avoid this, it helps to know these common signs of a bad MAP sensor:

  1. Check engine light is on. Your car's engine computer alerts you through your check engine light if your MAP sensor is acting up.
  2. Pinging sounds coming from your engine.
  3. Poor fuel economy.
  4. Lack of power.
  5. Failed emission tests.

Also know, what happens when your map sensor goes bad?

If the MAP sensor goes bad, the ECM can't accurately calculate engine load, which means the air-fuel ratio will become either too rich (more fuel) or too lean (less fuel). This leads to excessive fuel consumption, poor fuel economy, and possibly detonation. Lack of Power.

What does the map sensor control?

MAP Sensor and You In fuel-injected automotive engines, a manifold absolute pressure (MAP) sensor is used to continuously monitor the amount of air flowing into the engine, so the computer can calculate air density, adjust the amount of fuel to spray into the combustion chamber and adjust the ignition timing.

29 Related Question Answers Found

Is it bad to drive with a bad map sensor?

Can you clean map sensor?

Can you test a map sensor?


When should I replace my map sensor?

Will a map sensor cause a misfire?

Is MAF and MAP sensor the same?


What should the vacuum be at idle?

What is the symptoms of a bad mass air flow sensor?

Can you run a vehicle without a map sensor?


What type of sensor is a map sensor?

What happens if I unplug my MAF sensor?

Can you bypass mass air flow sensor?