Asked by: Regena Jafferbhoy
asked in category: General Last Updated: 23rd February, 2020

How do you adjust the high and low on a Husqvarna chainsaw?

  1. Locate the idle-speed screw and the idle-mixture screws on the side of the chainsaw.
  2. Turn both the low- and high-speed screws clockwise to the midpoint.
  3. Adjust the low-idle screw clockwise and counterclockwise respectively, until you find the highest idling speed.

Click to see full answer.


Similarly one may ask, how do I adjust my Husqvarna?

How to Adjust a Husqvarna Carburetor

  1. Set the Husqvarna chain saw on a level surface.
  2. Start the chain saw and allow the engine to warm for five minutes.
  3. Turn the screw with the "L" stamp clockwise with a screwdriver until the screw stops.
  4. Place the screwdriver on the screw with a "T' stamp.

Beside above, what does the L and H mean on a chainsaw? "On every saw the "h" means that's the "high" side adjustment. It regulates the fuel/air mixture that is being passed into the motor during high rpm's. The "L" means that's the "low" side adjustment. It regulates the fuel/air mixture that is being passed in the motor around the low rpm's"

Accordingly, what is the T adjustment on chainsaw?

Adjust the screw labeled 'L' until the chainsaw accelerates smoothly and sounds smooth. Place the flat-head screwdriver on top of the idle-speed adjustment screw which is labeled 'T. ' Turn the screw in a clockwise direction until the chain starts moving.

How do you know if your chainsaw is running lean?

Easy, all high rpms and very little power. If your saw revs to high heaven yet shows very little power in the cut chances are its running lean. If you rev your saw way up high out of the cut and it takes its real good time coming back to idle chances are its running lean Lean means too much air, not enuff fuel

38 Related Question Answers Found

Why does my chainsaw start and then stop?

Why does my chainsaw bog down when cutting?

How do you adjust a rich carburetor?


How tight should a chainsaw chain be?

What is 4 stroking on a chainsaw?

How do you adjust the H and L on a chainsaw?


Why does my Husqvarna chainsaw stall?

How do you adjust the idle speed on a Husqvarna chainsaw?