Asked by: Benedicta Mobs
asked in category: General Last Updated: 16th June, 2020

How do I turn off Eigrp?

To disable EIGRP, use the no router eigrp (1-65535) command. EIGRP must be enabled before carrying out any of the EIGRP commands. Specify vrf NAME if you want eigrp to work within the specified vrf. Disable EIGRP.

Click to see full answer.


Then, how do I disable Eigrp on my Cisco router?

shutdown (EIGRP) To shut down an instance of Enhanced Interior Gateway Routing Protocol (EIGRP), use the shutdown command. To disable this function, use the no form of this command.

how do I restart the Eigrp process? To restart an Enhanced Interior Gateway Routing Protocol (EIGRP) instance and remove all associated neighbors, use the restart command.

Also question is, how do you clear a route in Eigrp?

clear ip eigrp neighbors. To remove and reestablish the Enhanced Interior Gateway Routing Protocol (EIGRP) neighbor entries from the appropriate table, use the clear ip eigrp neighbors command.

What is graceful shutdown in Eigrp?

EIGRP Graceful Shutdown. The Graceful Shutdown feature allows EIGRP to advertise it is being deactivated. This means neighbours do not need to wait for hold timers to expired and can shutdown a neighbour immediately. The Graceful Shutdown is achieved by sending a hello packet with the K-Values all set to 255.

21 Related Question Answers Found

What is Eigrp configuration?

How do you configure Eigrp?

How do I enable Eigrp on an interface?


What is autonomous system in Eigrp?

Which command displays the neighbors discovered by Eigrp?

Does Eigrp use wildcard mask?


What is identified within the opcode of an Eigrp packet header?

What is OSPF routing protocol?

What is Q count in Eigrp?


What is Eigrp stuck in active?

What causes Eigrp flapping?

Do Eigrp as numbers have to match?


What is goodbye message received in Eigrp?