Asked by: Mfedal Eyckmann
asked in category: General Last Updated: 11th February, 2020

How do I adjust the pressure on my Craftsman air compressor?

Setting the cut-out pressure
Turn clockwise to increase (if you want a higher maximum pressure) or count-clockwise to decrease (if you want a lower maximum pressure. Open the drain valve and wait until the pressure drops low enough to start the compressor. Close the drain valve. Wait for the compressor to stop.

Click to see full answer.


Subsequently, one may also ask, how do you adjust the pressure on a governor?

A. Remove the top cover from the governor. C. To raise the pressure settings, turn the adjusting screw counter-clockwise. To lower the pressure settings, turn the adjusting screw clockwise.

how do you adjust the pressure on a compressor? Step-by-step procedure:

  1. Starting from an empty tank. Start the compressor and let it run until it reaches the cut-out pressure.
  2. Open a drain to slowly let some air escape. Watch how the pressure slowly comes down.
  3. Wait until the compressor starts.
  4. Adjust the cut-in pressure with the big set screw.
  5. Close the drain valve.

Considering this, why does my air compressor not shut off?

One of which is when your air compressor is not able to pump the necessary air to reach the cut out pressure switch level. It could be because of the failure of the intake valve and pressure valve, a broken gasket inside pump, or an impeding flow in the tank check valve.

What PSI should I set my air compressor?

The air pressure the compressor generates inside the tank is measured in Pounds Per Square Inch, or PSI. Light-duty compressors generally have 90 psi, which is typically sufficient for pneumatic tools for simple household tasks, including nailers. More powerful compressors may generate 150 psi or higher.

29 Related Question Answers Found

How do you adjust a compressor regulator?

What is cut in pressure?

What are the two gauges on my air compressor?


How do you adjust a pressure switch?

What does a pressure switch do on an air compressor?

Where is the pressure switch?


Where is the unloader valve on air compressor?

How does a pressure switch work?