Asked by: Rafaela Orero
asked in category: General Last Updated: 20th April, 2020

How do I add wireless sensors to Vista 20p?

Complete the following steps to program a wireless zone on a Honeywell VISTA-20P:
  1. Access system programming. Enter the installer code (the default code is 4112) + 800 on a keypad.
  2. Access zone programming. Enter * 56.
  3. Select a zone.
  4. Program the zone.
  5. Exit programming.
  6. Test the sensor.

Click to see full answer.


Subsequently, one may also ask, how do I program my Vista 20p?

To enter programming on a VISTA-20P alarm control panel, you can either enter your 4-digit installer code followed by [800] or, if you don't know your installer code, you can power the VISTA-20P down (remove battery backup and transformer) and then press [*] and [#] together within (50) seconds of powering back up.

how do I reset my Vista 20p installer code? See the VISTA-20P programming guide for other programming fields. First reset the installer code by pressing *20 followed by the 4 digit Installer code you wish to use. You will hear a beep after each digit entry, and 3 beeps after the final entry. You can reset other user codes once you know the installer code.

Also, how do I exit a program in Vista 20p?

Users can also exit programming mode by pressing star (*) 99. Entering star (*) 99 exits program mode and allows re-entry by entering the Installer Code + 8 0 0. Star (*) 99 is the recommended way to exit to programming mode. Please refer to the Vista control panel's programming guide for complete programming details.

How do you program a 6160 keypad?

There are two ways to enter programming on a Honeywell 6160 alphanumeric keypad. The easiest way to get into programming is to enter the Installer code (default = 4112) + [8] + [00]. If you do not have your installer code, and it has been changed from default, you will need to use the back door method to get back in.

32 Related Question Answers Found

How do I make Vista 20p default?

How do I change the time on my Vista 20p?

How do I program Vista 15p?


How do I reprogram my Honeywell keypad?

What is Zone doubling?